Zeiss Axiolab A Spezifikationen PDF herunterladen (Seite 52)

START-UP

Carl Zeiss Installing standard components Axio Lab.A1

52 430037-7144-001 04/2013

3.1.7 Mounting a mechanical stage

Axio Lab.A1 stands are fitted with the respective

mechanical stage at the factory according to

customer requirements.

The friction torque of the drive knobs is set at an

average value at the factory.

Should the stage need to be replaced or the stage

settings changed, proceed as follows:

3.1.7.1 Dismantling a stage

x Remove the four fastening screws (Fig. 3-10/4)

on the stage carrier (Fig. 3-10/2) using an SW 3

(Fig. 3-10/3) Allen wrench.

x Remove stage (Fig. 3-10/1) upwards from the

stage carrier.

3.1.7.2 Installing the stage

x Place stage (Fig. 3-10/1) onto stage carrier (Fig. 3-10/2) in such a manner that the threaded holes on

the bottom of the stage (Fig. 3-10/6) are positioned above the stage carrier openings (Fig. 3-10/5).

x Insert four fastening screws (Fig. 3-10/4) through the stage carrier from below and screw them into

the bottom of the stage.

x Turn the stage to orient it in an XY direction and tighten the fastening screws.

3.1.7.3 Setting drive length on stage drive

The length of the X and Y drives can be changed by shifting the respective drive knob (Fig. 3-11/4 or 1)

axially within a range of approx. 15 mm.

Fig. 3-10 Replacing a mechanical stage

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 117 118

Keine Kommentare

Zeiss Axiolab A Spezifikationen Seite 52