Zeiss Axiovert 135M Spezifikationen PDF herunterladen (Seite 64)

Axiovert 25, Axiovert 25 C, Axiovert 25 CFL

08/99 B 40Ć012 e

3Ć6

• Use the SW 3 screwdriver to loosen the clamping screw on the heatsink and remove the used

lamp.

 The cable on the heatsink must not be removed.

• Hold the new lamp on the marked metal base and insert it in the heatsink in such a way that its

reflecting part is at the bottom when inserted in the mount. The reflecting meltĆoff part of the

lamp must point to the side (to avoid interference with the image).

• Carefully tighten the clamping screw on the heatsink.

• Avoid fingerprints on the glass parts of the lamp; if required, remove fingerprints immediately.

• Press down spring lever and insert the lamp in the mount while holding it on the heatsink.

• Slowly release pressure from spring lever and let go of the heatsink.

 The heatsink must be aligned parallel to the lamp housing. The position of the

heatsink can be corrected by pressing down the spring lever and turning the heatsink.

• Attach the lamp housing to the lamp base and tighten screw (3Ć4ā/ā1).

• Attach the microscope illuminator to the microscope stand.

• Note down the number indicated on the operating hours counter of the power supply unit. The

HBO lamp must be replaced when the nominal life of 100 hours has been reached.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 75 76

Keine Kommentare

Zeiss Axiovert 135M Spezifikationen Seite 64